Every green at Bedford Hills in Temperance, Michigan traced contour by contour, with fall lines, daily pins, and live wind in the GolfCore app.
GolfCore is not affiliated with or endorsed by Bedford Hills Golf Club.
Bedford Hills drawn from GolfCore's traced course vectors — fairways, tees, greens, bunkers and
water, in the app's own colors. This is the same geometry the app maps a round on.
One of 18 mapped greens at Bedford Hills, drawn from GolfCore's contour data baked from
USGS 3DEP 1-meter lidar, in the same colors the app uses.
Elevation bands run cool-low to warm-high; white lines are contours at a 3-inch interval, and dark arrows point down the fall line.
Bedford Hills plays 3 layouts, each with its own tees. Picking a tee shows that tee's own yardages, pars and stroke indexes where the club has rated them. Clubs correct their own data in the app.
What GolfCore has for Bedford Hills
GolfCore's library covers Bedford Hills Golf Club green by green: 18 putting surfaces traced with
148 elevation contours from USGS 3DEP 1-meter lidar. The steepest measured slope on these greens tilts at
6.9 percent — the difference between a putt that dies at the hole and one that runs
four feet past.
In the app, players and caddies read the same data live on the course: contour bands with fall-line arrows,
wind simulated at the player's position, and pin positions that clubs on GolfCore set each morning. Bedford Hills Golf Club is one of more than six thousand courses GolfCore has mapped green by green.
For clubs, the same system runs the tee sheet and the caddie yard — assignments off real tee times, SMS
confirmations, and a caddie network that spans every club on the platform. Read how
caddie management on GolfCore works.
Staff at Bedford Hills can claim this course by
signing in with an email address at the club's own domain. That sets the club up on GolfCore with
you as an administrator.
GolfCore maps courses from public elevation data and is not affiliated with or endorsed by
Bedford Hills. Represent this club? Request changes or removal through
our contact page.
